collecting data from 212/100

Post general discussions on using our drivers to write your own software here
Post Reply
Lucio
Newbie
Posts: 1
Joined: Wed Jan 19, 2005 5:05 pm

collecting data from 212/100

Post by Lucio »

Hi there,

i'm using the 212/100 to read a voltage signal froma pressure gauge.
I must confess that practically I don't konw anything about programming...

...so please can you tell me how I can store in a file the data that the oscilloscope prgressively collects?

i've installed the r5_11_08 version and the drivers weba200_r4_00.

i've tried with DDE, but the data are overwritten everytime.
I've also tried to launch the execl macro and see if I could put my hands in and change some setting but it tells me:

Unable to open ADC-200
ADC200 Driver V4.01
Error 13 (H0 S0)


and before that when it says:

Select Tools/Macro
Select GetData
Press Edit
Set the following variables:


there are no specifications on which variables to set!!!

please let me know asap because i'm stuck with my work!!!
Thanks,

Lucio

Sarah

Post by Sarah »

Hi

Thank you for your post.

Would using our Picolog software help? This enables you to record the data that is coming in and you can then export it to Excel after it has been collected. This would be easier than writing your own software.

Hope this helps

Best Regards

Post Reply