Serial TC-08 driver

Post your LabVIEW discussions here
Post Reply
ka_torce
Newbie
Posts: 0
Joined: Thu Nov 28, 2013 12:08 pm

Serial TC-08 driver

Post by ka_torce »

Hello,

I have downloaded the Software development Kit R1.0.0 available for the Serial Tc-08 product from:
http://www.picotech.com/software.html

but when I try to open the vi files in labview 2011 it says that cannot run it since it was built using Labview 4 which is quite old.
Can you please provide an updated vi example for using the Serial TC-08 with Labview.

Thank you.
regards.

Hitesh

Re: Serial TC-08 driver

Post by Hitesh »

Hi ka_torce,

If you have access to an early version such as LabVIEW 7.1 you can open the vi file and save it for that version. You should then be able to open this in LabVIEW 2011.

This webpage may be of interest:

http://www.ni.com/white-paper/8387/en/

If you are not able to do this above, then please post back here.

Thanks,

ka_torce
Newbie
Posts: 0
Joined: Thu Nov 28, 2013 12:08 pm

Re: Serial TC-08 driver

Post by ka_torce »

Hello,

thanks for your answer but unfortunately I do not have access to previous Labview versions. Any option?
Thank you.
Regards.

Hitesh

Re: Serial TC-08 driver

Post by Hitesh »

Hi ka_torce,

I will look into this further.

Another option is to use the serial protocol for the device which is provided in section 3.4 in the Programmer's Guide.

Regards,

Post Reply