can't display 2 channels on screen

Forum for discussing PicoScope (version 5)
Post Reply
keith49090
Newbie
Posts: 0
Joined: Tue Aug 20, 2013 7:49 pm

can't display 2 channels on screen

Post by keith49090 » Tue Aug 20, 2013 7:58 pm

Trying to compare cam & crank signals together and can only get crank signal to show up. Tried switching channels to no avail. I'm new to using pico and may not have settings right.

Martyn
Site Admin
Site Admin
Posts: 3374
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: can't display 2 channels on screen

Post by Martyn » Wed Aug 21, 2013 12:17 pm

Make sure that the second channel is not set to Off on the toolbar at the top of the screen, select either Auto or a set range from the drop down menus.
Martyn
Technical Support Manager

Post Reply