Excel logging with ADC-11

Post general discussions on using our drivers to write your own software here
Post Reply
RonyJ

Excel logging with ADC-11

Post by RonyJ »

Hi.

I'm using the Excel GetAdc11 macro which is supplied with the ADC11 unit. All works fine ... however I would like to be able to re-run the macro after it has been executed. If I do this at the moment it says Unable to open ADC (and I have to close Excel and re-open it before it works again).

I've tried to call adc11_close_unit subroutine... to close the active "connection" to the ADC11 device...but I couldn't seem to get it working.

Is there a way to automatically close this "connection" after the macro has run ... so that the macro can be re-run at a later time (without restarting the.xls file).

Thanks

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

I am sorry to hear that you are experiencing this problem.

I have replicated this problem as stated and passed it on to the development department, unfortunately there is no time scale I can give you for when the fix will be available.

Best regards,
Regards,

Mark Spencer

RonyJ

Post by RonyJ »

Thanks Mark,

I'm eargerly waiting a resonse !! :wink:

Post Reply