Picolog 1012 series - USB dataloggers

Post any questions you may have about our current range of USB data loggers
Post Reply
Ken Howell
Newbie
Posts: 1
Joined: Mon Dec 12, 2005 1:08 pm

Picolog 1012 series - USB dataloggers

Post by Ken Howell »

Hi

We have just received a new Picolog 1012 series - USB datalogger, and after following the instructions the unit seemed be installed correctly. I configured it for one channel only, created a file, and set it to run. Instead of the expected small noise signal as seen on previous Pico devices (Parallel ADC-11 and USB ADC-11) the reading was static showing a constant zero.

Grateful for your advice on what is going wrong.

Ken

Hitesh

Re: Picolog 1012 series - USB dataloggers

Post by Hitesh »

Hi Ken,

Does the reading for the channel fluctuate at all in the PicoLog Recorder window?

Have you tried testing the input by connecting something like a 1.5V AA battery or connecting the 2.5V output from the terminal board to channel 1?

You can also check readings by running the PicoScope 6 software with the device.

Regards,

Post Reply