case for 3206 MSO

Post any questions you may have about our current range of oscilloscopes
Post Reply
blachanc
Newbie
Posts: 1
Joined: Fri Feb 01, 2013 2:49 pm

case for 3206 MSO

Post by blachanc »

Hi,
Greetings from Canada,

I just ordered a 3206 MSO from your Canadian distributor (interworld).
From the description, I understand that the PicoScope Carry Case is not
compatible with my scope.

Do you have plans to build a case for the MSO series, or do you have any
generic case that you know other customers are using.

Regards,

Benoit

Hitesh

Re: case for 3206 MSO

Post by Hitesh »

Hi Benoit,

There are no current plans to provide a carry case for the 3000 MSO products.

The only option at this moment would be cut out a section of the foam to accomodate the extra BNC connector on the rear of the product.

Hope this helps.

blachanc
Newbie
Posts: 1
Joined: Fri Feb 01, 2013 2:49 pm

Re: case for 3206 MSO

Post by blachanc »

I received the scope & case today.

You were right,
I used an old fashion razor to cut the foam in the front and in the back of the picoscope case.
I am left with 1/4 inches from the back, but this is fine, as the back of the case is lying against the padding.

Ben

Hans Inoue
Newbie
Posts: 0
Joined: Wed Apr 01, 2015 9:28 pm

Re: case for 3206 MSO

Post by Hans Inoue »

I purchased 3403D. Which carry case is fit? Give me a parts No..

Hitesh

Re: case for 3206 MSO

Post by Hitesh »

Hi Hans,

Could you please e-mail support@picotech.com and we will look to assist you further.

Regards,

Post Reply