Startup settings

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
Sylvester
Newbie
Posts: 0
Joined: Thu Oct 25, 2012 11:34 pm

Startup settings

Post by Sylvester » Thu Oct 25, 2012 11:40 pm

Hi there Picoscope team,

Great product you have, thanks for all the hard work.

This is just a feature suggestion (that hopefully wouldn't take too much time on your part). I often find myself switching between two boards I am working on and I seem to continuously have to change the setting on my scope (one board is I2C and the other RS232). It'd be great if there was the possibility of saving multiple 'start-up settings' and being able to load alternative ones when needed.

Thanks
Mark

Martyn
Site Admin
Site Admin
Posts: 3333
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Startup settings

Post by Martyn » Fri Oct 26, 2012 6:07 am

When you have a set up you like go to File->SaveCurrentWaveformAs and change the type to pssettings. This will create a file that you can click on to launch the program with the desired settings.
Martyn
Technical Support Manager

Post Reply