Part of display trace missing for channel C

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
CoyoteDavid
Active User
Active User
Posts: 17
Joined: Fri Jan 05, 2007 7:48 am
Location: California

Part of display trace missing for channel C

Post by CoyoteDavid »

I have a 4424 displaying 2 channels, A and C. I only get part of the C channel displayed. How much displays depends on the contents of the A channel. See attached display. Is this normal?
Attachments
Display problem on channel C, part of trace is missing.
Display problem on channel C, part of trace is missing.

Hitesh

Re: Part of display trace missing for channel C

Post by Hitesh »

Hi CoyoteDavid,

Which version of the PicoScope 6 software is installed on your PC?

Try installing PicoScope 6.6.43 (RC) from http://www.picotech.com/software.html

If the problem still occurs, please send a psdata file to support@picotech.com

Thanks,

CoyoteDavid
Active User
Active User
Posts: 17
Joined: Fri Jan 05, 2007 7:48 am
Location: California

Re: Part of display trace missing for channel C

Post by CoyoteDavid »

I tested it with 6.6.46.1 and got the same results. Will send the psdata file as requested.
The version you listed was not available...

Hitesh

Re: Part of display trace missing for channel C

Post by Hitesh »

Resolved - the signal on Channel C was saturating as the voltage range was set at +/- 5V. The voltage range required increasing.

Post Reply