pico scope signal generator and wireless connection

Forum for discussing PicoScope (version 5)
Post Reply
swift46

pico scope signal generator and wireless connection

Post by swift46 »

I have the acd212, softwear 5.10.7
When I try to use the signal generator the menue shows waveform and sweep mode operation that I can not access, why?

I would like to connect the acd212 box to a wireless so that I can leave my lap top on the bench and move the box with probes around the car, can I can I do this? how? Thank you.

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

Thank you for your post. The box that is displayed with the signal generator, is the same box for all our products. The ADC-212 range can only produce a 0 - 250,000 Hz TTL signal. It does not have the option for Triangle, Signal, or Sweep modes availalbe. The series that these are available to is the Picoscope 3000 series.

Unfortunately, it is not possible to use a radio modem between the ADC-212 and PC.

Best regards,
Regards,

Mark Spencer

Post Reply