Test and Measurement Forum

Clocking in data to picolog 1216

Post any questions you may have about our current range of USB data loggers

Clocking in data to picolog 1216

Postby RandB » Wed Feb 08, 2012 3:17 pm

I have a question.

I am trying to gather data synchronised to a rising edge of one of the inputs but cannot see a way this can be done.

I am running under the following settings:
• Channels 0-11 are the data I want to capture
• Channel 15 is the master synchronisation clock – currently at 1.6kHz (could reduce this if necessary)
• Fast block recording, stop after run
• Number of samples – currently 150, but would bring this right down to circa 16 if I could sync the data.
• I seem to be able to capture data at 6kz ish

I tried to set for 1 sample and then repeat immediately (i.e. re-arm the trigger) but the minimum number of samples is 10 which is incompatible with the clock

Is there a way this can be done?
Posts: 0
Joined: Wed Feb 08, 2012 3:15 pm

Re: Clocking in data to picolog 1216

Postby Martyn » Wed Feb 15, 2012 9:11 am

Are you restricted to using Picolog or are you able to write your own application to achieve this ?

I would also suggest contacting the helpdesk at support@picotech.com
Technical Support Manager
Site Admin
Site Admin
Posts: 3225
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Return to USB PC Data Loggers

Who is online

Users browsing this forum: No registered users and 0 guests