time data acquisition

Forum for discussing PicoLog
Post Reply
FogGio
Newbie
Posts: 0
Joined: Wed Sep 14, 2011 3:10 pm

time data acquisition

Post by FogGio »

Hi I'm a new user
I'm try to use Picolog to detect the time of flight of a wave.
In particular I want to detect automatically the time distance between CH. B trigger (or between vertical cursor) and the maximum peak of CH. A,
The max peak position will vary in a defined time range (between two vertical cursor).
Is there any esay way to do it ?
If it's possible I need also to storage the collected value.
THANKS

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: time data acquisition

Post by Martyn »

It is not possible to automatically make measurements between two waveforms on different channels using the PicoLog software. To achieve this you either need to manually make the measurements or would need to look at writing your own software to analyse the data.
Martyn
Technical Support Manager

Post Reply