Test and Measurement Forum


Post any questions about our parallel port products


Postby ljosborne27 » Thu Aug 04, 2011 2:10 am

ADC-212 with automotive was installed on my old laptop.Not sure what version it was but I had the ability to add custom probes ,record data up to 1000 frames ect.When I had to replace my laptop due to a hard drive failure I can no longer find a software version newer than 5.2 I believe it is.Wondering how to get it back to where it was.Any help would be nice it has been a couple monthes now Thanks LJ

Re: ADC-212

Postby Martyn » Thu Aug 04, 2011 11:12 am

You can download software from our website at http://www.picotech.com/software.html

Select the appropriate product at Step 1 and you are offered different versions of software at Step 2

If you can't find what you require then please contact us through our support desk at support@picotech.com

Kind regards
Technical Support Manager
Site Admin
Site Admin
Posts: 3218
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: ADC-212

Postby PeterF » Fri Aug 19, 2011 12:49 pm

I think you were actually using the automotive version of PicoScope6, which will run on the ADC-212. It is available here:-
http://www.picoauto.com/download.html?s ... &x=87&y=15
(No other parallel port scopes will work with it though.)
Advanced User
Advanced User
Posts: 435
Joined: Thu Jun 07, 2007 10:53 am
Location: Cambridgeshire

Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests