ADC-11 I/O pin allocation

Post any questions about our parallel port products
Post Reply
Heath

ADC-11 I/O pin allocation

Post by Heath »

Hi, Maybe this is a dumb question but I have searched all the documentation for the ADC-11 and cannot find the pin allocation table for the channel inputs, please can you help. Many thanks.

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: ADC-11 I/O pin allocation

Post by ziko »

Its a good question! ITs not in the main manual, the USB ADC11 will have the pin layout ontop of the logger itself, on the parallel ADC11 and the USB ADC11 there is a terminal board pin out in the terminal board manual:

http://www.picotech.com/document/pdf/ad ... s-en-5.pdf

Kind regards
Ziko

Technical Specialist

Heath

Re: ADC-11 I/O pin allocation

Post by Heath »

Hi Ziko,
Many thanks for your reply. I have looked in the terminal board manual but it does not actually give the 25pid D connector pin out. I assume channels 1 to 11 are on pins 1 to 11 but what about the digital out and the ground?

Best Regards Heath.

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: ADC-11 I/O pin allocation

Post by ziko »

Hi this is the USB ADC11 I/O pin, the parallel ADC11 will be the same apart from the fact it has only one Digital Output.

Kind regards
Attachments
adc11inputs.jpg
Ziko

Technical Specialist

Post Reply