Long

Post any questions you may have about our current range of oscilloscopes
Post Reply
MarioFM

Long

Post by MarioFM »

I have purchased a picoScope series 2205 from you a few months ago.
For a project I am working on, I determined that the signal’’s frequency is around ~250 kHz. To be able to decode the signal I will need longer samples than what the scope can hold as a waveform.
I figured out that between buffers there is some signal lost and I don’t think that a continuous signal can be reconstructed concatenating several waveforms.
Is there some software that run with the scope to get a longer signal? (around a few seconds worth of signal)
What are the options for data recorders?
20100917-2120.psdata
This is a sample of the signal
(196.65 KiB) Downloaded 437 times

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: Long

Post by ziko »

Hi there will be an associated delay between buffers, the only way to get round this is to write your own software really.

Kind regards
Ziko

Technical Specialist

Post Reply