When I connect to my logger, so cannot I see any scale-data in my monitor-view. Only then i put the channel configuration/location/"edit sensor" to raw value (4-20mA)
Shell I change something in my enviromon.ini file to?
/Mankan
Ok.. thank you.
But I have set up my configuration channel (to EL037) same as you.
And it swork not so good for me. I can not see any data!
I can only see data (4-20mA) if i set up my configuration to reed 4-20mA.
(I can se data if I switch my Sensor dropdown box in "sensor information" to 4-20mA and connect to my logger and send over the new program..)
But I can not get any data when I choose my sensor in dropdown box, that sensor I have created(after that I have send over my new program to logger).
I have tried the scaling file more throughly, and I have found a problem, not with your scaling file, but with the Enviromon application. While using your scaling file I could only get readings when the ampage went above 7.2mA.
This has been reported to our development team and listed for bug fix, unfortunately, I am unable to provide a current time scale.
For a exampel. One of my channel work fine, the rawdata is about 6.189 mA and this channel can show me a calculate data. But, another channel ho have rawdata about 8.616 mA can not show me any calculate data. These channel has same NoOfPoints in USER.PSC
In some cases can I read the calculate data, only if I have 5 NoOfPoints, not 6 NoOfPoints in my USER.PSC-file ?!?