how to get the reading from the unit itself?

Ray · Post by **Ray** » Thu Dec 24, 2009 12:35 am

How do I get my voltage, current and temperature reading once i install the picolog recorder software and plug in the data logger 1012 to a small terminal board PR112 and which hole must I connect it to at the small terminal board PR112 to get my reading?

PeterF · Post by **PeterF** » Sun Dec 27, 2009 6:03 pm

Hi,
The full answer to your question would be far longer than it is sensible to put in an email. I attach links to the PicoLog 1012 manual:-
http://www.picotech.com/document/pdf/pl1000-en.pdf
PicoLog program manual:-
http://www.picotech.com/document/pdf/plw044.pdf
Small terminal board manual:-
http://www.picotech.com/document/pdf/Sm ... sGuide.pdf
If you cannot get going using them, please contact via email at the help-desk:-
support@picotech.com
or by phone:- 01480-396395
on or after 4th January when the factory is again open.
Regards,
PeterF.

Ray · Post by **Ray** » Mon Dec 28, 2009 6:47 am

Thank alot for the help admin.. really appreciate alot =)

Test & Measurement Forum

how to get the reading from the unit itself?

how to get the reading from the unit itself?

Re: how to get the reading from the unit itself?

Re: how to get the reading from the unit itself?