I try go get the 2204 work with the Vee Demo programm.
I switch the Vee 9.0 in 6.0-7.0 execution mode.
The programm starts and the init seems to work. The internal relays click some times.
But if I start the measurement, the function >wait for data< waits forever.
Any ideas?
Is the Windows DLL only for 20xx scopes?
I am also trying to run some legacy VEE code which runs ok with the 2203 and does not run with the 2204. I tried the new example and its does not work. It fails at the open scope point which returns a zero handle (not ready) Any clues? We are building a bunch new test rigs and planned to integrate the new PICO scope into these and so I gotta get this working please!!
I can get both scopes work ok with picoscope 6, and both start the initialisation process. any clues would be good.
I have a new 2204A and I am comparing with the old 2203. I note the new 2204A does not run with the old version old pico-scope either. Would I get better results if i bought a 2204 instead of the 2204A? I have just tried a new installation my lap top in case i had legacy problems and this is the same. I tried PS2000.vee from this thread and the one bundled with the CD that came with the 2204A
That's what I just did on the lap top and it didn't work. I have tried the same here on a desktop and still returns a zero handle indicating its not ready? I have also tried rebooting the PC's and powering the scope on and off and this seems to have no effect, pico scope 6 is the only thing that works. The old 2203 works with all of this.