5000D vs 5000B

Which product is right for your exact requirements
Post Reply
packo
User
User
Posts: 6
Joined: Wed Aug 09, 2017 9:59 pm

5000D vs 5000B

Post by packo »

Hello,

I can see that the new 5000D series is out.

Apart from the MSO option, the higher memory and the single usb3 port powering, are there any other revisions in terms of specifications versus the 5000B series?

Thanks in advance!

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: 5000D vs 5000B

Post by Martyn »

That just about covers it :)

The USB3 port is not just for powering but allows data transfer between the device and the PC to performed more quickly so the scope is ready to go again in a shorter time frame. If writing your own applications using the SDK then sustainable streaming speeds are significantly faster at up to 125MS/s shared across active channels
Martyn
Technical Support Manager

packo
User
User
Posts: 6
Joined: Wed Aug 09, 2017 9:59 pm

Re: 5000D vs 5000B

Post by packo »

Thank you for the response.

Have there been any changes in the dependency between vertical resolution and min input sensitivity ?

From the specs I understand that with 5000D a min sensitivity of 2mV/div is now possible in 16bit mode (14 bits resolution) whereas
for 5000A/B, min sensitivity of 2mV/div was only possible with 8bit mode (16bits was available from 10mV/diV and above)?

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: 5000D vs 5000B

Post by Martyn »

2mV/div (+/-10mV range) is available for the 5000A/B models with 16bit

Nothing has changed in this area, however the layout of the specifications and how the information is presented has.
Martyn
Technical Support Manager

dfergenson
User
User
Posts: 2
Joined: Fri Mar 04, 2016 8:58 am

Re: 5000D vs 5000B

Post by dfergenson »

I noticed the following passage in the 5000D specifications sheet: "Trigger tools allow you to output one or more cycles of a waveform when various conditions are met, such as the scope triggering or a mask limit test failing."

I assume that this means that the AWG can be used to produce a trigger output pulse.

Is this correct?

Can a 5000A series oscilloscope perform the same function?

I apologize if this is covered in the manuals but I was unable to find a precise answer when I looked and the 5000A series specifications sheet does not have a similar passage regarding the Gen output.

Thanks.

-David

dfergenson
User
User
Posts: 2
Joined: Fri Mar 04, 2016 8:58 am

Re: 5000D vs 5000B

Post by dfergenson »

I believe that I've just answered my own question.

The question was wether the waveform generator in the 5000A, B and/or D could be triggered to output on scope trigger. The answer is yes in all three instruments.

The answer is in the PicoScope 6 User's Guide. The table on page 219, column ST shows which of the models allow this feature. All 5000 series oscilloscopes are indicated as allowing waveforms to be generated upon triggering.

The details as to how to select this are given on page 144 of the same document.

-David

Post Reply