Test and Measurement Forum

Decoding of the MDIO Interface

Post general discussions on using our drivers to write your own software here

Decoding of the MDIO Interface

Postby thomasdon » Mon Feb 19, 2018 8:14 am

Hi

Are there any projects or librarys for decoding the MDIO Interface (Ethernet PHY to MAC)?
With I2C I can trigger the frames, but they aren´t decoded correctly.

Correct decoding and triggerpossibylity an read/write, PHY# and register adress would be fine for debugging :D.

Kind regards

Thomas
thomasdon
Newbie
 
Posts: 0
Joined: Mon Feb 19, 2018 8:04 am

Re: Decoding of the MDIO Interface

Postby Martyn » Thu Feb 22, 2018 8:08 am

Can you post a psdata file with an example of the data you are trying to decode.
Martyn
Technical Support Manager
Martyn
Site Admin
Site Admin
 
Posts: 3108
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Decoding of the MDIO Interface

Postby thomasdon » Thu Feb 22, 2018 8:15 am

Hi Martyn

I attached a file with several MDIO recordes.
I used I2C because it is as close at possible to the MDIO Interface.

A description of the MDIO interface you can finde there
https://en.wikipedia.org/wiki/Management_Data_Input/Output

Trigger on read/write, PHY#, PHY adress would be finde.

Kind Regards

Thomas
thomasdon
Newbie
 
Posts: 0
Joined: Mon Feb 19, 2018 8:04 am

Re: Decoding of the MDIO Interface

Postby Martyn » Mon Feb 26, 2018 9:43 am

The attachment hasn't made it through, can you try sending it to support@picotech.com
Martyn
Technical Support Manager
Martyn
Site Admin
Site Admin
 
Posts: 3108
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests