Measuring Current with an ADC11

Having problems ? let us know the details here
Post Reply
Jasper
User
User
Posts: 6
Joined: Mon Mar 17, 2008 9:27 pm

Measuring Current with an ADC11

Post by Jasper »

Can anybody help,

I am waiting for my adc11 to arrive. i am intending to measure the output 4-20Ma current from 4 shock sensor units.

Can anybody give me a heads up as to how to set up the unit or what i should look out for etc, i have read some of the posts and they do not go into to much detail, this is fairly new to me as i normally rely on dedicated measuring devices for the sensors we use, however i am keen to move into different areas and experiment

Many thanks for any help

Jasper

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi Jasper have you had a look at the ADC11 terminal board instructions

http://www.picotech.com/document/pdf/ad ... ons-en.pdf

Section 2.2. gives a description on what you need to do measure current.

Also the PicLog Manual will give you an idea of how to set the unit up:

http://www.picotech.com/document/pdf/plw044.pdf

To give you a brief idea of how the softwre works, you initially create the settings, via File->New Settings. Once you have done that you create a data file to record the data to, via File->New data.

You may also be interested in using the scaling section when creating your settings, please have al look at section 5.1.8.2 Parameter scaling for more information.

Hope this helps.

Kind regards
Ziko

Technical Specialist

Guest

Post by Guest »

Thanks zICO

i will take a good look later today

Jasper

Guest

Post by Guest »

the sensors i am using are shock pulse and give a 4-20 Ma output so the highest recorded current would be 20 Ma

however when you measre the voltage across the outpu terminals you also get 22vDc

The adc only takes up to 2.5 volts so do i need to carry out the process as described in measuring voltage as well?

Thanks

Jasper

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi if there is no load the voltage will rise to approximately the supply voltage that is why you need a load resistance of say 120 ohms. This will limit the voltage to 480mV at 4 mA and 2.4V at 20mA.

Hope this helps.

Kind regards
Ziko

Technical Specialist

Post Reply