Test and Measurement Forum

Trigger of Signal Generator on 5444A

Post your LabVIEW discussions here

Trigger of Signal Generator on 5444A

Postby Shogo » Mon Dec 18, 2017 8:06 am

I am using 5444A. Is it possible to generate pulses synchronized to the data aquisition trigger that is taken from ch A?
Although I have tried "PicoScope5000aAWG.vi", pulses from signal generator were not synchronized to the scope trigger no matter what "Trigger Source" was selected.
Shogo
Newbie
 
Posts: 0
Joined: Tue Aug 02, 2016 9:57 am

Re: Trigger of Signal Generator on 5444A

Postby Hitesh » Mon Dec 18, 2017 9:33 am

Hi Shogo,

You may wish to refer to this document.

You can set the signal generator to output a defined a number of cycles of a waveform or start sweeping between two frequencies on a trigger event, including when a trigger condition is met on the scope input channels.

What parameters have you set on the call to the library function?

Regards,
Hitesh

Technical Support Engineer
Hitesh
Site Admin
Site Admin
 
Posts: 2549
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to LabVIEW

Who is online

Users browsing this forum: No registered users and 0 guests