Test and Measurement Forum

PicoScope2000ExampleFastStreaming.vi channel B doesn't work

Post your LabVIEW discussions here

PicoScope2000ExampleFastStreaming.vi channel B doesn't work

Postby Thomas76 » Tue Dec 05, 2017 3:53 pm

Hi,
I have a Picoscope 2204A and I'm using PicoScope2000ExampleFastStreaming.vi to read my signal.
If I use Channel A all works correctly but if I use Channel B it doesn't show any signal.
When I use Channel A, I enable Channel A Settings and I use Channel A as Trigger Source in Front Panel;
when I try to use Channel B, I enable Channel B Settings and I use Channel B as Trigger Source in Front Panel.

I noticed that PicoScope2000StartStreaming.vi (used in PicoScope2000ExampleFastStreaming.vi) have Channel A and Channel B output. In PicoScope2000ExampleFastStreaming.vi only Channel A is used. I tried to use Channel B output instead of Channel A but the result doesn't change.

Can anyone tell me how to set input parameters of PicoScope2000ExampleFastStreaming.vi to use Channel B?

P.S.: With PicoScope6 program Channel B works correctly.
Thomas76
Newbie
 
Posts: 0
Joined: Tue Dec 05, 2017 3:28 pm

Re: PicoScope2000ExampleFastStreaming.vi channel B doesn't w

Postby Hitesh » Tue Dec 05, 2017 5:20 pm

This has been resolved via Live Chat request.

For the benefit of other Users, the PicoScope2000StartStreaming.vi sub-vi has an output for a data buffer for channel B. Connect a wire to the terminal, just like for channel A, if you wish to see live data or alternatively, if you just need to see the data at the end, then you can output an array from the call to the ps2000_get_streaming_values_no_aggregation() function.

Regards,
Hitesh

Technical Support Engineer
Hitesh
Site Admin
Site Admin
 
Posts: 2655
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to LabVIEW

Who is online

Users browsing this forum: No registered users and 0 guests