I know how this tool works, but when I capture one trace on the 2nd screen, the first one disappear and the composite screen shows only one trace. Remember I use single trigger mode. I think this tool does not work with this trigg mode.
I am sorry to hear that you are experiencing this problem. I have tried to the freeze/thaw functionality with the composite view without incident
The version of the software I was using was Release 5.18.0. I noticed that you where using an older version of the software Release 5.16.12, I would recommend that you upgrade to the newer version and then try the freeze/thaw and composite function again.
Following your advice, I ´ve downloaded the new version 5.18.0.
However there is a problem when I use single trigger. If I use AUTO there is no problem. Also I reduced the number of samples but the the result is the same.
Changing the trigger from single to auto and vice versa the scope re start and it can capture a new trace. Then I open a Composite view and works OK.
I going to use this procedure to capture differents traces to make a comparison.
Regards,
Ariel.