I am trying to use the signal generator in picoscope-6, but after setting up the signal type, frequency and amplitude in the software I am not able to visualize it on the screen.
please help if I need to do some additional setup on software/hardware
Thanks
Test and Measurement Forum
Signal generator
2 posts
• Page 1 of 1
Signal generator
by anand123456 » Thu Sep 28, 2017 7:03 am
- anand123456
- Newbie
- Posts: 1
- Joined: Wed Sep 27, 2017 1:25 pm
Re: Signal generator
by Martyn » Thu Sep 28, 2017 8:05 am
To see the signal you would need to feed it back into one of the input Channels.
Martyn
Technical Support Manager
Technical Support Manager
- Martyn
- Site Admin
- Posts: 3108
- Joined: Fri Jun 10, 2011 8:15 am
- Location: St. Neots
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests
