about signal generator

Post any questions you may have about our current range of oscilloscopes
Post Reply
shijinquan
Newbie
Posts: 0
Joined: Wed Aug 30, 2017 9:20 pm

about signal generator

Post by shijinquan »

Hello,

I am using the picoscope 2206 for my tests and and I am facing a problem. When I connect the scope with my computer and open the software then click the signal on, however, signal can not be changed and the signal can not control the signal. But when I use the Demo model, everything goes well. Anyone knows the reason? Is there a problem with my picoscope?

Thanks

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: about signal generator

Post by Martyn »

Have you connected the output of the signal generator to the input Channel A using a BNC cable or scope probe, probe tip into the AWG connector BNC end on Channel A
Martyn
Technical Support Manager

Post Reply