Test and Measurement Forum

about signal generator

Post any questions you may have about our current range of oscilloscopes

about signal generator

Postby shijinquan » Wed Aug 30, 2017 9:26 pm


I am using the picoscope 2206 for my tests and and I am facing a problem. When I connect the scope with my computer and open the software then click the signal on, however, signal can not be changed and the signal can not control the signal. But when I use the Demo model, everything goes well. Anyone knows the reason? Is there a problem with my picoscope?

Posts: 0
Joined: Wed Aug 30, 2017 9:20 pm

Re: about signal generator

Postby Martyn » Thu Aug 31, 2017 5:41 am

Have you connected the output of the signal generator to the input Channel A using a BNC cable or scope probe, probe tip into the AWG connector BNC end on Channel A
Technical Support Manager
Site Admin
Site Admin
Posts: 3177
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests