PicoScope 7 Software
Available on Windows, Mac and Linux
Automation with multiple scopes
-
jackdigitalinsight
- Newbie
- Posts: 0
- Joined: Sat Jul 15, 2017 9:17 pm
Automation with multiple scopes
I have two 4444 scopes running (s/w 6.12.2687) on one PC. Is there a way to direct command-line automation ("picoscope /a ...") to a specific running instance?
I know the SDK allows opening specific devices, but I'd like the pretty trace graphs that the PicoScope GUI application creates rather than just capturing raw data and building the graph myself, not to mention using the GUI to configure settings.
Also, is there any documentation beyond the "picoscope /a ?" output, or at least a way to get help on specific commands?
Thanks.
I know the SDK allows opening specific devices, but I'd like the pretty trace graphs that the PicoScope GUI application creates rather than just capturing raw data and building the graph myself, not to mention using the GUI to configure settings.
Also, is there any documentation beyond the "picoscope /a ?" output, or at least a way to get help on specific commands?
Thanks.
-
Hitesh
Re: Automation with multiple scopes
Hi Jack,
Could you please e-mail support@picotech.com in order to discuss this further please?
In terms of further information, this post shows the command to use to find the list of available automation commands.
Regards,
Could you please e-mail support@picotech.com in order to discuss this further please?
In terms of further information, this post shows the command to use to find the list of available automation commands.
Regards,