Counting rising edges

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
scal3
Newbie
Posts: 0
Joined: Wed Nov 09, 2016 9:38 am

Counting rising edges

Post by scal3 »

I'm having PicoScope 6 count the number of rising edges in a signal.

At lower frequencies it works good but at higher frequencies it doesn't report anything at all.

The shortest pulse cycle is about 5 ms and the recorded data shows the pulse train clearly.
See attached image.
Attachments
Zero pulses counted
Zero pulses counted

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Counting rising edges

Post by Martyn »

This will be due to the way the data is currently downsampled for the measurements engine.

Are you able to provide a psdata file for this, we are currently working on this section of the code, and we can test the file against the internal builds.
Martyn
Technical Support Manager

Post Reply