Since 1991 we have been supplying the world with test and measurement equipment. At Pico we realize that your choice of test accessories can be almost as important as your choice of test equipment. Here you can purchase a variety of test and measurement accessories quickly and securely online.

A3076 750 MHz active oscilloscope probe

The Pico A3076 Series high-impedance active oscilloscope probe has minimal impact on the signal being probed with maximal signal transfer to the PicoScope 6000E Series. Its ergonomic design allows comfortable handheld use with a button to start and pause capturing in PicoScope 6.

The Intelligent Probe Interface powers the probe from the scope and facilitates automatic probe detection and unit scaling. The probe can set scope attenuation and automatically switch to 50 Ω input impedance.

With an input resistance of 1 MΩ and capacitance of 0.9 pF, this active probe offers high input impedance up to 750 MHz. These characteristics make this probe the most versatile for many of your day-to-day measurements

A3000 750 MHz and 1.3 GHz active oscilloscope probes
Available for back order. More stock coming soon.
£799

Accessories for the A3076 750 MHz active oscilloscope probe

Product Price Quantity
A3000 Series replacement consumables kit
PQ275
£15
A3076 active probe specifications
Bandwidth DC to 750 MHz into 50 Ω load
DC to 500 MHz nominal system bandwidth with PicoScope 6000E 500 MHz oscilloscope
Rise time < 466 ps
DC gain accuracy ±3% of full scale over 15 to 40°C, after 20-minute warmup

DC offset accuracy

±3 mV over 15 to 40°C, after 20-minute warmup
Input characteristics 1 MΩ || 0.9 pF
Attenuation 10:1
Dynamic performance (typical)
Noise 2.5 mV (RMS) referred to probe input
Pulse response < 10% overshoot
Bandwidth flatness (+1 dB, –3 dB) from DC to full bandwidth
Low-frequency flatness < ±3% (or ±0.3 dB) from DC to 250 MHz
Propagation delay 5.4 ns
Input voltage
Full scale ±5 V (DC + AC peak)
Absolute max. voltage  ±30 V (DC + AC peak) subject to frequency derating
DC offset range ±10 V
DC offset control accuracy ±1% of offset setting, additional to DC accuracy above
General
Probe detection Automatic with any oscilloscope with Pico Intelligent Probe Interface (IPI)
Operating temperature range 0 to 50 °C
For quoted accuracy:15 to 40 °C after 20-minute warmup.
Storage temperature range –20 to +60 °C.
Operating humidity range 5% to 80% RH non-condensing
Storage humidity range 5% to 95% RH non-condensing
Altitude range Up to 2000 m
Pollution degree EN 61010 degree 2 : “only nonconductive pollution occurs except that occasionally a temporary conductivity caused by condensation is expected”
Dimensions (probe body) 108 mm (L) x 16 mm (H) x 12 mm (W) 
Cable length 1.2 m
Safety compliance EN 61010-031:2015
EMC compliance Tested to EN61326-1:2013 and FCC Part 15 Subpart B
Environmental approvals RoHS, WEEE, REACH