|
|
| Author |
Message |
Gumper
Guest
|
 Posted: Thu Jul 01, 2004 2:28 pm Post subject: adc200_ets_time functions in labview |
 |
|
I was wondering were i could find information of the setup for the ets library functions in labview. I downloaded the manual but did not see the ets described. I just need to know the parameters that go along with
these functions. I wold be very thankfull for just a point in the right direction.  |
|
| Back to top |
|
 |
markspencer
Site Admin
Joined: 07 May 2003
Posts: 610
|
| Posted: Fri Jul 02, 2004 7:51 am Post subject: |
|
|
Hi,
Thank you for your request. The information on the ets function can be found in the help manual. If you look under the heading driver routines this should give you all the required details.
Best regards, |
|
| Back to top |
|
|
gumper
Guest
|
| Posted: Tue Jul 06, 2004 4:25 pm Post subject: adc_set_ets |
|
|
I might just be looking in the wrong place, but i have downloaded the adc 200 manual and i only see 22 adc200 routines explained. Maybe if you could be a little more specific on were i am to find all of the routines explained. Sorry about no being able to find them.
gump |
|
| Back to top |
|
|
markspencer
Site Admin
Joined: 07 May 2003
Posts: 610
|
| Posted: Wed Jul 07, 2004 8:01 am Post subject: |
|
|
Hi,
I am sorry to hear that you are having difficulty finding the routines. I believe that you have downloaded the .pdf files. Unfortunately, the routines seem to be missoing form this document. I would recommend that you download the electronic manual. You can this manual when downloading the examples and installing them onto your PC.
Best regards, |
|
| Back to top |
|
|
gumper
Guest
|
| Posted: Thu Jul 08, 2004 2:11 pm Post subject: Thanks |
|
|
I did end up finding it i was just being dumb. However i did have another question. Does the ADC212-50 have the capability to use equivalent time sampling through labview? I ask because when i use adc200_get_ets_time and adc200_get_max_ets I only get a values of 20 and 100 respectfully. Does this mean that i do not have the proper set up or that these are just the constant values of the scope. O just to let you know i am taking your trigger interface and trying to add the three ETS routines, is there any thing else i have to do before adding these.
Thank you for all your great help |
|
| Back to top |
|
|
|
Cart
Email