|
|
| Author |
Message |
nodrog
Guest
|
 Posted: Sun Oct 26, 2003 4:07 pm Post subject: output on drdaq |
 |
|
| does the software supplied allow the inputs to control the output e.g. the p.H. level rises too high the output can be used to contol a pump to level out the p.H. (closed loop feedback). |
|
| Back to top |
|
 |
markspencer
Site Admin
Joined: 07 May 2003
Posts: 610
|
| Posted: Mon Oct 27, 2003 8:57 am Post subject: |
|
|
Hi,
It is not possible to control the digital output through Picolog or Picoscope, however, this is possible if you were to write your own software. The voltage that can be recieved through the DO is in the range 3-5 volts depending on the PC. The maximum current draw is about 2 mA, trying to draw to much current could have an adverse effect on your PC. It would be better to use the DO as a trigger which would switch something on rather than power/drive an external device.
Best regards, |
|
| Back to top |
|
|
Guest
|
| Posted: Fri Nov 14, 2003 6:53 pm Post subject: Related Question |
|
|
Sorry to butt in on your thread.  But I am considering purchasing th Dr Daq to do something similar to what youre require e.g. control a motor when ph is too high or low...
Is there any avliable software to do this on the DRDAQ device?
Thanks |
|
| Back to top |
|
|
markspencer
Site Admin
Joined: 07 May 2003
Posts: 610
|
| Posted: Mon Nov 17, 2003 8:18 am Post subject: |
|
|
Hi,
Unfortunately, there is nothing in the software that will allow you to control the motor through Picolog/Picoscope.
However, it might be possible to do it by writing your own software and using the digital out to trigger a relay.
Best regards, |
|
| Back to top |
|
|
|
Cart
Email