Pico Technical Support and Discussion Forum

jack pramudito · User Joined: 03 Jul 2007 Posts: 4 Location: indonesia

dear all

I am new user of PICO product, recently i was buying new ADC11/12 USB and already tried to interface with my laptop. Software interface installation is no problem occur, datalogger software may work correctly, strange operation happened when I use PICOSCOPE software ver 5.15.6 - 32 bit, my laptop always gone to 'blue screen', reporting error at dump memory. I tried with two different laptop (IBM R61 and HP NC6000), both seemed same problem, does anybody can help me solving whats going on happen with my hardware?

regards

jack

ziko · Posted: Tue Jul 03, 2007 7:45 am Post subject:

Hi and thank you for your post.

What operating system are you using on each of the machine?
What is the specification of the computers?
What settings did you have the software on and actions you have taken for the software to cause this problem?

The more information you can provide the quicker we can find a solution to your problem?

Kind regards

jack pramudito · User Joined: 03 Jul 2007 Posts: 4 Location: indonesia

Thanks for your prompt reply..

1. Operating system installed both on my machine is Microsoft Windows XP Proffesional Service Pack 2.
2. hardware Specification : - IBM R61 - intel core 2 duo processor 2.4 GHz - 1 GB RAM - 120 GB HDD - USB 2.0 compatible the others Hewlett packard Compaq NC6000 - intel pentium m - 1.7 GHz - 512 MB RAM - 80 GB HDD
3. I was setting use Picoscope software, opening 8 new scope to detect voltage input on 8 channel, just 5 minute only monitoring then my laptop going blank so 'blue screen' error reported there was error in my system, after that computer going on reset. I did not tried using a desktop pc, will this make different result than using laptops?

regards

Jack

ziko · Posted: Wed Jul 04, 2007 10:18 am Post subject:

Hi if you could email us the dump file that was created when you get the blue screen, if you go into system properties on you computer and choose the advanced tab and select "Start Up and Recovery".

Then tick the boxes as shown, when the error occurs next time, windows will create a dump file, which will be in the following location:

C:\WINDOWS\Minidump

if you could email this file I will forward it to one of our software engineers to see if they can identify the problem.

Kind regards

jack pramudito · User Joined: 03 Jul 2007 Posts: 4 Location: indonesia

Hi, here I sent you and error file generated by Windows, tested with my other machine, IBM R51 - Centrino 1.65 GHz, 512 MB RAM and 40 GB HDD, operating system Microsoft Windows XP Proffesional SP2. Just one minute I execute Pico scope software and then going blank.

I hope there will any error identification and solving my problem.

thankyou.

Jack

jack pramudito · User Joined: 03 Jul 2007 Posts: 4 Location: indonesia

Sorry, its seems extension .dmp not allow to send, here i send again a file .dmp file with .jpg extension, you may change to original .dmp after download this file.

thankyou

jack

ziko · Posted: Wed Jul 04, 2007 12:29 pm Post subject:

Could you send it as a zip file instead because it does not seem to have sent the file correctly. Or you could send me the file as a Private Message. Also could you save the settings you have and send that as well.

Kind regards

Pico Technology

Pico Technical Support and Discussion Forum