problem with picolog installation and sample rate

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
Author Message
maverick
Guest
PostPosted: Mon Jun 12, 2006 3:15 am    Post subject: problem with picolog installation and sample rate Reply with quote
Hi,

I met a problem when I install latest version of Pico_version_r5_13.9, I used ADC-11. After I finished installation, both Picoscope and Pico player can run properly, however, Picolog only flash out and then disappeared, I can't use it to collect the data. What is the problem? Another thing I want to know is about sample rate of ADC-11, it seems that ADC-11 can only capture voltage data correctly when sample rate>=1000ms, less than that sample rate, the voltage reading is always changing. why is that? it is supposed user can select much faster sample rate in the options.

You will be highly appreciated for your help!

Maverick
Back to top
Michael
Guru
Guru


Joined: 07 Jul 2005
Posts: 93
Location: St Neots, Cambridgeshire
PostPosted: Mon Jun 12, 2006 10:13 am    Post subject: Reply with quote
Hello,

Thank you for your post.

The USB ADC11 sampling rate is 20Ks/Sec which is divided by the number of active channels. The high sampling rates are available in the block mode sampling section. Real time continuous mode will give you a maximum of 900-1000 samples/sec.

I hope this helps.

Best regards,
Michael
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group