|
|
| Author |
Message |
Nanjizal
User
Joined: 15 Mar 2005
Posts: 2
|
 Posted: Tue Mar 15, 2005 11:31 pm Post subject: TC-08 & DrDAQ together |
 |
|
I've used the serial TC-08 via USB successfully for a long time, and have now added the LPT1 DrDAQ for pH measurement. I was relying on doing these altogether - is this possible?
Can I run 2 instances of PicoLog? How?
Many thanks,
Pete |
|
| Back to top |
|
 |
Sarah
Guest
|
| Posted: Wed Mar 16, 2005 9:40 am Post subject: |
|
|
Hi
Thank you for your post.
It is possible by selecting "Use Multiple Converters" in the first box when setting up new settings.
Therefore you should not need to run two instances of Picolog. It is however possible to do this and there is full information in the Picolog help manual.
Hoep this helps
Best Regards |
|
| Back to top |
|
|
Nanjizal
User
Joined: 15 Mar 2005
Posts: 2
|
| Posted: Wed Mar 16, 2005 3:52 pm Post subject: |
|
|
Hi, thanks for reply,
However, from your help screen I see that multiple channels is under 'recording', which is not available if DrDAQ installed (see your dialogue box - "Note: this dialog box is not displayed if you installed PicoLog for use with DrDAQ.")
Thanks again... |
|
| Back to top |
|
|
Sarah
Guest
|
| Posted: Thu Mar 17, 2005 11:30 am Post subject: |
|
|
Hi
Thank you for your post.
You can get round this by installing for a different unit. If you go through the installation process again but select, say, "ADC-11" then it will install for that and you will get the mulitple converters option available. You can then change the converter manually as you go through the settings process.
Hope this helps
Best Regards |
|
| Back to top |
|
|
|
Cart
Email