Test and Measurement Forum

Hi,

Have just installed my ADC100.
Have set the bios to SPP
Have added fo:2 patch
Have added useadapter into win.ini
Am using parallel port adapter

After doing all the above the scope now works, but the logger only shows about 1/10th of the signal being inputted.

Any ideas please?

picofan

Hi

Thank you for your post.

Does the signal look like a small noisy square wave?
Which version of the software are you using? If you have had to put in the f0:2 patch then this is a very old version.

I recommend downloading our latest version - R5.12.0 which was uploaded onto the internet today.

Hope this helps

Best Regards