Test and Measurement Forum

Hello,

I want to use the Picoscope 2204. I read the docs of the software but I didn't find an answer to my question:
I want to use the input signal on one of the scope inputs to trigger the AWG output. For example: A single pulse arrives at the input of the scope. The trigger of the scope detects it and the pulse is displayed. After an adjustable time (around 150 us) the AWG starts and outputs the signal stored in its memory once then stops. Is this possible and how can I realize it?

Very best regards

Elektrix

This is not possible with the PicoScope 2204

Thank you for the info!

Best regards

Elektrix