It is currently Tue Mar 16, 2010 4:38 pm

All times are UTC




Post new topic Reply to topic  [ 6 posts ] 
Author Message
 Post subject: location of camshaft positioning sensor on 2000 dodge neon
PostPosted: Thu May 04, 2006 1:08 pm 
looking for the location of camshaft positioning sensor on a dodge neon. 2.0 l 16 valve engine


Top
  
Reply with quote  
 Post subject: CMP
PostPosted: Thu May 04, 2006 4:27 pm 
Offline
Zen Master
Zen Master

Joined: Wed Nov 20, 2002 4:19 pm
Posts: 255
Location: Washington State USA
Should be at the rear of the cylinder head.

_________________
Tom Roberts
(The Picotologist)
http://www.autonerdz.com
skype: autonerdz
THE PicoScope Automotive Authority
In North America


Top
 Profile  
Reply with quote  
 Post subject: camshaft positioning sensor
PostPosted: Fri May 05, 2006 4:43 am 
is there anything special i have to do to replace one...can u tell me any tricks i need to know... thx for the response


Top
  
Reply with quote  
 Post subject: CMP
PostPosted: Fri May 05, 2006 3:41 pm 
Offline
Zen Master
Zen Master

Joined: Wed Nov 20, 2002 4:19 pm
Posts: 255
Location: Washington State USA
No, not really. Just nuts and bolts. Did you confirm a failure with your scope?

_________________
Tom Roberts
(The Picotologist)
http://www.autonerdz.com
skype: autonerdz
THE PicoScope Automotive Authority
In North America


Top
 Profile  
Reply with quote  
 Post subject: location of camshaft on a 2000 dodge neon
PostPosted: Tue Sep 15, 2009 2:46 am 
:? I am having a problem with locating the postion where the camshaft is on a 2000 Dodge Neon[/i]


Top
  
Reply with quote  
 Post subject:
PostPosted: Tue Sep 15, 2009 7:09 am 
Offline
Guru
Guru

Joined: Thu Nov 21, 2002 5:17 am
Posts: 54
Location: Missouri, USA
The single overhead camshaft is located in the cylinder head just below the rocker shafts. There should be a reference mark on the camshaft sprocket for alignment.

If you are trying to check to see if the camshaft is in the proper position in relation to the crankshaft, then do what Tom suggested and check it with your scope while monitoring CKP and CMP signals. If they are timed correctly, you saved yourself tear-down time.

Another technique used by some is the use of a pressure tranducer placed in the combustion chamber. Interpreting those results can be a challenge unless you're real famiiar with it.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 0 guests


You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO