Pico Technical Support and Discussion Forum

Hi

This vehicle is an Isuzu Wizard with a 3.0TD 4JX1 engine, it is a non start, I have scoped the cam and crank sensor [hopefully attached] and a know good trace [again hopfully attached] The crank trace polarity is reversed on the non start. Can anyone help me with what can cause this. I tried the non start ECU in the running car and it worked OK.

Here is the wave forms

These vehicles need oil pressure to make the injectors work, its a heui system. Connect the tech 2 to it, look at desired and actual rail pressure, they should follow each other, minimum of 4 mpa to start. You will need a 5w 30 oil in it, criticlal for starting.

Hope this helps


Andy

I know it's a bit late for a reply. But just learning, so good practice. Was the problem a flat battery? Basing that on the differences in peak voltages, the duration of of the hi/low areas of the signals. And also evidence of starter draw from the wavey peaks.
Were the probes connected the same way when you got this inverted pattern?

Hi

1. Is some one know why is the crank signal miss tooth is different (the good wave is up 12v and the bad wave down 0v)
2. what is the interruption in cam/crank wave is? it is show in crank wave and cam.

Thanks

shay