Test and Measurement Forum

Hello

I'm writting a new windows software for the usb adc11 device. I'm using the usbadc11.dll .
Now i'm wondering how to set the digital output with this driver. Is it possible?

Many thanks in advance

tobias hofer

Hello Again

I managed to set the digtial outputs on the adc11/12. But now i have
a problem with collecting datas in block.

when i use the fucntion GetTimeAndValue(...) i always recieve only 40 samples.

does anybode know how to fix this problem?

best regards
tobias hofer

Hi tobiashofer,

Have you tried to recreate this using PicoLog? If you still have the same problem then the unit might have a problem with the PC, which affects a small percentage of PCs.

Kind regards

I tested the data logger with pico log and reading a block of data.

It also dosn't work with pico log!

>If you still have the same problem then the unit might have a problem with >the PC, which affects a small percentage of PCs.
Is there a new driver or bugg fix? The datalogger is for an automative testsystem and should work on every pc.

best regards

hofer tobias

Hi tobiashofer,

I would try to install it on another computer and see if you encounter the same problems.

Kind regards