BNC inputs CAT I/II/III

 
Post new topic   Reply to topic    Pico Technology Forum Index -> USB PC Oscilloscopes
Author Message
Guest
PostPosted: Thu Jun 22, 2006 6:46 pm    Post subject: BNC inputs CAT I/II/III Reply with quote
Hi there...

We are looking at getting a portable scope for field work. We measure powerline stuff... like rf over powerline in the 150KHz range... but we also need input voltage protection too. I was wondering if the inputs on the 3206 for example was CATI CATII or CATIII rated like desktop scopes?
What is the maximum voltage you can measure with a 1x probe? etc etc.
Think these products are suitable?
Also when not in the field, we'd be doing development work, standard PIC chip stuff with dsPICs.

Jeff
Back to top
Michael
Guru
Guru


Joined: 07 Jul 2005
Posts: 93
Location: St Neots, Cambridgeshire
PostPosted: Fri Jun 23, 2006 9:57 am    Post subject: Reply with quote
Hello,
At present, our scopes do not conform to CATI, II & III standards. Our differential input probe is CATIII rated for your safety. YOu will be able to measure high voltages with this probe.

Further information can be found her:
http://accessories.picotech.com/oscilloscope_probes.html

Best regards,
Michael
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> USB PC Oscilloscopes
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group