Failed to find ADC16 when RF enabled

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
Author Message
Winston
Guest
PostPosted: Wed Oct 12, 2005 12:04 pm    Post subject: Failed to find ADC16 when RF enabled Reply with quote
Hi:
I have an application where I need to log data remotely. I used a type of wireless modem to relay data wirelessly. First I used two computers both connected with the wireless modems and they can communicate via Hyperterminal at baud rate 57600 bps, which is the com setting of two computers. Then I connect ADC16 with one wireless modem, seperately powered up ADC16 with +- 5V power supply. PicoLog then failed to find ADC16 but I can see from the LEDs on the wireless modem that the two have communicated with each other. I assume there is a timeout window in your PicoLog, during which a reponse from ADC16 is expected. If this is correct, is there any possibility this timeout window can be extended?

Another test I did then is to connect ADC16 directly with computer and seperately power up ADC16 with +- 5V power supply, PicoLog find it straight away.

Thanks

Winston
Back to top
Michael
Guru
Guru


Joined: 07 Jul 2005
Posts: 93
Location: St Neots, Cambridgeshire
PostPosted: Thu Oct 13, 2005 9:00 am    Post subject: Reply with quote
Hello,

I will reply to your post by email.

Best regards,
Michael
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group