ADC-42 Trigger setup

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Parallel Port Products
Author Message
tmcdonagh
Guest
PostPosted: Mon Oct 03, 2005 7:34 pm    Post subject: ADC-42 Trigger setup Reply with quote
I have an ADC-42. I would like to trigger collection of data. My equipment puts out a contact closure at the start of a run. Can I utilize this closure to initiate data collection? I also have a ADC-16 serial unit if that will work. My detector puts out 1 volt full scale and another puts out 10 mV full scale.

Best regards,

Tom
Back to top
Michael
Guru
Guru


Joined: 07 Jul 2005
Posts: 93
Location: St Neots, Cambridgeshire
PostPosted: Mon Oct 10, 2005 11:27 am    Post subject: Reply with quote
Hello,

Thank you for your post.
You can record using block mode to make use of triggers.

You will not be able set triggers in real time continuous modes.

Best regards,
Michael
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Parallel Port Products
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group