hi, question about signal generator

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Parallel Port Products
Author Message
guest
Guest
PostPosted: Wed Jun 01, 2005 8:01 pm    Post subject: hi, question about signal generator Reply with quote
hi, i was using the signal generator hooking it up to channel B. why is it offset by 0.5V? in settings i had the offset turn off
Back to top
Sarah
Guest
PostPosted: Thu Jun 02, 2005 9:14 am    Post subject: Reply with quote
Hi

Thank you for your post.

There should not be an offset on the signal generator. Which unit are you using? What signal generator settings are you using?

Best Regards
Back to top
guest
Guest
PostPosted: Thu Jun 02, 2005 4:27 pm    Post subject: Reply with quote
3205 , the signal generator settings are 5V Squarewave at 1khz
Back to top
Sarah
Guest
PostPosted: Fri Jun 03, 2005 10:06 am    Post subject: Reply with quote
Hi

Thank you for your post and the information.

I have tried this out and do not see an offset with the unit that I used. Could you send me a .psd file showing what you are seeing to tech@picotech.com and also include a link to this thread so that I can check back at what has already been said?

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Parallel Port Products
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group