ADC 100 - Pico scope works, logger doesn't display signal

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
Author Message
picofan
Guest
PostPosted: Fri Feb 11, 2005 11:23 am    Post subject: ADC 100 - Pico scope works, logger doesn't display signal Reply with quote
Hi,

Have just installed my ADC100.
Have set the bios to SPP
Have added fo:2 patch
Have added useadapter into win.ini
Am using parallel port adapter

After doing all the above the scope now works, but the logger only shows about 1/10th of the signal being inputted.

Any ideas please?

picofan
Back to top
Sarah
Guest
PostPosted: Fri Feb 11, 2005 11:37 am    Post subject: Reply with quote
Hi

Thank you for your post.

Does the signal look like a small noisy square wave?
Which version of the software are you using? If you have had to put in the f0:2 patch then this is a very old version.

I recommend downloading our latest version - R5.12.0 which was uploaded onto the internet today.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group