Power waveforms

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
Author Message
dudrik
Guest
PostPosted: Tue Feb 01, 2005 9:28 am    Post subject: Power waveforms Reply with quote
Hi! I have two questions to the same problem - multiplication of waveforms:
1. Is it possible to multiplicate two waveforms ( voltage and current) to obtain power waveform ?
2. Is it possible to change the quantity ? For example, if the current is sensed by current probe then the output is ussualy in 10mV input range of oscilloscope. Can I change this letś say to 10A ? and obtain power in Watts? Thanks!
Back to top
Sarah
Guest
PostPosted: Tue Feb 01, 2005 10:01 am    Post subject: Reply with quote
Hi

Thank you for your post.

It is not possibl to do what you descibe in Picoscope, however you can do it in Picolog.

In Picolog you can scale the results you recieve so that a 10mA signal could display as 10A. You can also then set up "Calculated Parameters" which enable you to multiply together (or add, subtract etc) the results from different inputs.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group