Vp-p and Phase Measurement in VB

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoScope
Author Message
JSmith
Active User
Active User


Joined: 07 Dec 2004
Posts: 6

PostPosted: Wed Jan 12, 2005 4:02 am    Post subject: Vp-p and Phase Measurement in VB Reply with quote
Hello

Is there a command or line of code in VB for the PicoScope 3000 series that can measure Vp-p?

Same question but for measuring the phase between two inputs?

Cheers
Jye
Back to top
Sarah
Guest
PostPosted: Wed Jan 12, 2005 11:09 am    Post subject: Reply with quote
Hi

Thank you for your post.

Unfortunately there is not a function that will provide the Pk-to-Pk
voltage. The only results obtainable from the unit are ADC counts these results being proportional to the voltage range set in ps3000_set_channel, and the time each sample was take, with the first sample being 0, unless a post or pre trigger is in use. All manipulation of the raw values are left up to the user.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoScope
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group