PC216 as an ATE measurement system

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
Author Message
alunh
Guest
PostPosted: Thu Sep 09, 2004 9:59 am    Post subject: PC216 as an ATE measurement system Reply with quote
Hi,
I am looking at building a PC based ATE system using the ADC-216 as the the measurement engine.

Most of the measurements would be things such as signal peak voltage, distortion, noise etc

Does the software drivers provide support for these sort of measurements ?
Do do they just return raw data and then I would have to do the maths crunching afterwards ?

Thanks

Alun
Back to top
Sarah
Guest
PostPosted: Thu Sep 09, 2004 2:19 pm    Post subject: Reply with quote
Hi Alun

Thank you for your post.

The data returned from the drivers that we supply would be raw data, so you would have to make the calculations yourself.

Many calculations are done in our Picoscope software, however if you are writing your own software you will need to include the calculations into your program code yourself.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group