ADC-216 Compatible 100x Probes?

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
Author Message
Dr Deville
Guest
PostPosted: Tue Sep 07, 2004 10:44 pm    Post subject: ADC-216 Compatible 100x Probes? Reply with quote
Greetings Forum,

I am considering the ADC-216 for vacuum tube audio gear testing, which means measuring signals that may range as high as 1KV.

Seeing as the 216's maximum range is 20V, I'm thinking this means I need to use a 100x probe for this application, correct?

I'm considering the Probe Master 4910-2 for this application, as shown here:

http://www.probemaster.com/oscilloscopeprobes4900.html

Could you please tell me if this probe is compatible with the 216? If you have any other 100x probe recommendations, I'd enjoy knowing them as well.

Thank you for your time and assistance,

George Ferguson
Back to top
Sarah
Guest
PostPosted: Wed Sep 08, 2004 11:52 am    Post subject: Reply with quote
Hi George

Thank you for your post.

The probe that you mention should work fine with the ADC-216. As long as the voltage input to the unit does not exceed ±20V then a probe is usually suitable.

We do ourselves sell a X10/X100 probe that you might also like to consider. More information on this unit is available at:

http://accessories.picotech.com/oscilloscope_probes.html

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group