pico scope signal generator and wireless connection

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoScope
Author Message
swift46
Guest
PostPosted: Mon Jul 26, 2004 3:08 pm    Post subject: pico scope signal generator and wireless connection Reply with quote
I have the acd212, softwear 5.10.7
When I try to use the signal generator the menue shows waveform and sweep mode operation that I can not access, why?

I would like to connect the acd212 box to a wireless so that I can leave my lap top on the bench and move the box with probes around the car, can I can I do this? how? Thank you.
Back to top
markspencer
Site Admin
Site Admin


Joined: 07 May 2003
Posts: 610

PostPosted: Tue Jul 27, 2004 9:22 am    Post subject: Reply with quote
Hi,

Thank you for your post. The box that is displayed with the signal generator, is the same box for all our products. The ADC-212 range can only produce a 0 - 250,000 Hz TTL signal. It does not have the option for Triangle, Signal, or Sweep modes availalbe. The series that these are available to is the Picoscope 3000 series.

Unfortunately, it is not possible to use a radio modem between the ADC-212 and PC.

Best regards,
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoScope
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group