4 channel logger for torque, speed and temperature

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
Author Message
Pam
Guest
PostPosted: Thu May 13, 2004 3:04 pm    Post subject: 4 channel logger for torque, speed and temperature Reply with quote
Hi

I'm looking for a 4 (or more) channel, 10kHz logger that can be used to record torque (2 channels), speed and temperature.

Could the ADC-11/10 be used for this purpose? If so, what form would the input from the sensors need to take (Volts/Current)?

Thanks
Pam
Back to top
markspencer
Site Admin
Site Admin


Joined: 07 May 2003
Posts: 607

PostPosted: Fri May 14, 2004 8:15 am    Post subject: Reply with quote
Hi,

Thank you for your post.

The ADC-11/12 has 10,000 samples per second which is divided between the active channels, so the sampling rate of 10Khz is not obtainable while looking at 4 channels at the same time.

Unfortunately, we do not have a single unit that has 4 channels and a 10kHz sample rate on each channel. To achieve this you would need to use multiple units. Further to this you would also have to write your own software.

If you are considering the above then I would recommend looking at the ADC-212/3.

Best regards,
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group